Philips CDD260 User Manual page 15

ADDITIONAL INFORMATION
Ele ctrical interface (front of drive)
- Headphone Jack.
- RMS OUTPUT voltage: 3,1 V at 600 r .
- Signal-to-Noise Ratio: 80 dB typ. A weighted.
Electrical interface (rear of drive)
- Audio line out: RMS OUTPUT voltage 1V at 470 .
- Signal-to-Noise Ratio: 80 dB typ. A weighted.
- Data interface: 50 pin SCSI flatcable (see below).
- Power Supply:
Audio performa nce
Audio specification for line out:
Output Voltage
Unbalance
Output Impedance
Amplitude Linearity
S/N-ratio
Total Harmonic
Distortion + Noise
Outband attenuation
Channel separation
Muting level during
random access
- voltage requirements: +12V (± 5%) +5V (± 5%)
- current requirements: +12V
On pressed CD
1 V rms
max 0.25 dB
100 Ohm
1 dB (20 Hz - 20 kHz)
82 dB (87 dB A-wtg)
65 dB
(1kHz)
min. 50 dB above 25 kHz
min. 70 dB (20 kHz)
min. 90 dB (BW = 20 kHz)
ADDITIONAL INFORMATION
160 mA typ.
200 mA max.
+5V 1 A typ.
1,5 A max.
On recordable CD
1 V rms
max 0.25 dB
100 Ohm
2 dB (20 Hz - 16 kHz)
80 dB (85 dB A-wtg)
55 dB
(1kHz)
min. 50 dB above 25 kHz
min. 65 dB (16 kHz)
min. 90 dB (BW = 20 kHz)