Tub/Motor Assembly Service - GE WCCB1030WYC Technical Service Manual

TUB/MOTOR ASSEMBLY
To Service Tub/Motor Assembly
1. Remove front panel, cover/lid, remove agitator
by using belt tool, insert under agitator and pull up
sharply.
2. Remove split ring and washer from transmission.
3. Remove front rod and spring asm. (one at a time)
by lifting motor tub assembly up to take weight off
suspension bellows at lower portion of the rod. Pull
the bellows out of the leg and platform asm., and
allow them to hang freely. The front and the rear
rod and spring assembly have different springs that
are color coded and shouldn't be switched.
4. The motor and tub assembly will now lean for-
ward after both front suspension rods are removed.
This allows clearance to remove unhook the two
rod and spring assemblies in the rear.
5. Disconnect motor harness connector, and
grounding wire to frame, pressure switch hose at
takeoff. Save plastic ties to redress hoses as shown.
6. Disconnect hose from bottom of tub to pump.
7. Lift and push bottom of tub/motor assembly to-
wards the rear, and roll top of tub out under top lip
of cabinet.
NOTE: An alternate method is to lift complete
assembly by the platform at the bottom and set
it out first, pulling the assembly out the front.
The tub is flexible and can be rolled out under
the cabinet frame.
8. Roll tub out per illustration.
9. Pull tub out of apron by tilting it over on its top as
shown in illustration
I 0. Reverse steps to reassemble.
PULL TOP OUT FRONT
PUSH BOTTOM IN
TILT TUB OUT FRONT
SET TUB UP AS SHOWN
(ALTERNATIVE METHOD IS
REVIEWED IN TEXT AT LEFT
17