Troubleshooting - Salton Elite SECM21 Instructions And Warranty Information

place the descaler deposit in the water tank at least 15 minutes before brewing
the water.
3. Brew the water according to the program of making espresso coffee without
coffee powder in the filter.
4. Turn strength knob to "STRONG" or "LIGHT" position, then turn switch on by
pressing it to the "I / ON" position and approx. 3 min later water will flow out, after
making 2 cups hot water, turn the switch off by changing the switch to the
"O/OFF" position.
5. Turn strength knob to "STEAM" position, press the switch to the "I / ON" position
and make steam for 2min, then turn off switch to stop the unit immediately
6. Restart the unit and repeat step 3-5 at least 3 times.
7. Then turn strength knob to "STRONG" or "LIGHT" position, brew the coffee until
there is no descaler left.
8. Then brew coffee (no coffee powder in filter) with tap water in the MAX level,
repeat step 3-5 for 3 times, finally change the switch to the "I / ON" position and
brew the coffee until no water is left in the tank.
9. Repeat step 8 at least 3 times to make sure steam pipe is clean.
TROUBLE SHOOTING
SYMPTOM
Carafe leaks water or
water leaks out from the lid
of the carafe.
Espresso coffee drops out
too slowly (Not only for the
coffee maker with pump)
CAUSE
The carafe is not located
properly
The level of water in the
tank exceeds the scale of
MAX.
Ground coffee too fine
9
CORRECTONS
Align the centreline of
carafe with leakage opening
of the brew basket well.
The water level in the tank
should be within the scale of
MIN and MAX.
Try using a different coffee
powder.