Cleaning And Maintenance - Salton Elite SECM21 Instructions And Warranty Information

150 grams of milk (whole milk or half whole milk) for each cappuccino to be
prepared, place it on the right bottom part of the housing, lift up the cup to ensure
the nozzle is immersed in the milk, then turn the steam knob in an anti-clockwise
direction slowly when it begins foaming the milk, when the volume of milk frothing
is increased to 1.5 times the milk volume, turn off the steam knob to stop making
steam. When there is still water remaining in the tank, one can still make more
espresso coffee.
Note: In choosing the size of cup, it is recommend the diameter is not less than 70±
5mm, and bear in mind that the milk increases in volume by 1.5 times, make sure the
height of the cup is enough to accommodate that capacity.
Note: to get a better effect, move the cups constantly up and down.
2. Mix the espresso coffee with the foam milk and stir them with a spoon, add
chocolate powder if necessary.
3. Grasp the nozzle with your hand and the other on the coffee maker, then take the
nozzle down according to the direction of the steam pipe, after cleaning,
assemble it and place it back in the original position.
Caution: operate carefully because the nozzle will be hot after foaming and only
operate it again after it's cooled down.
Note: to prepare more than one cappuccino, first make all the coffees, and then at
the end prepare foam milk for the cappuccinos.

CLEANING AND MAINTENANCE


This coffee maker is for household use only and is not user-serviceable.

Do not open or change any parts by yourself. Please refer to a qualified electrical
service department or return to the supplier if servicing is necessary.

Always remember to unplug the unit from the electrical outlet when not in use
and before cleaning. Ensure that the speed control is set to "0".

It is much easier to clean the accessories directly after they have been used.
Wash them in warm, soapy water, rinse and dry well.

The body of the coffee maker and the stand should be cleaned with a damp
cloth. Do not let water enter the coffee maker or the stand.

Do not use bleach or other abrasive substance or solvents to clean your coffee
maker as it can be damaging to the finish.
7