Salton Elite SECM21 Instructions And Warranty Information page 5


MAKING DRIP COFFEE
1. Open the tank cover (for drip coffee) and pour proper drinking water into the
water tank according to the gauge.
2. Place the nylon filter into the funnel; make sure it is assembled correctly.
Otherwise the tank cover cannot be closed.
3. Add ground coffee into the nylon filter with a measuring spoon, a spoon of
ground coffee power can make a cup of top-grade coffee, but you can adjust
according to your preference.
4. Close the tank cover; insert the drip carafe onto the "keeping warm plate"
horizontally.
5. Plug the power cord into the outlet; place the switch to the "I/ON" position, the
indicator switch will be illuminated. The appliance will begin working. You may
stop the brewing process by placing the switch in the "O/off" position at any time.
To continue brewing, change the switch to the "I" position again.

MAKING ESPRESSO COFFEE
1. Turn the water tank cover in an anti-clockwise direction to open (see figure1),
and then fill adequate water through the carafe into the water tank.
Note: Always switch off the power and remove the plug from wall outlet before filling
up with water. Ensure water will not overflow water tank.
2. Turn the water tank cover in a clockwise direction tightly to close (see figure 1),
and then turn the steam knob in a clockwise direction to the end. (see figure 2).
COLSE
Figure 1
3. Place a permanent filter into the filter holder and fill the filter with coffee powder
according to your desire with a measuring spoon (marked with 2 and 4 cups) and
tap down coffee powder, then remove the excessive powder on the top rim.
4. Assemble the filter holder into the coffee maker, the method is as follows: first
align the mouth of the filter holder with the sprinkling mouth, hold the handle of
STEAM
OPEN
Figure 2
5
Figure 3