Disassembly And Reassembly Hints; Disassembly Procedures - Mitsubishi MJ-E16VX-S1 Service Manual

9. Disassembly and Reassembly Hints

9.1 Disassembly Procedures

1. Remove the water tank
2. Removing the front panel, and air filter
assembly
Step 1) Push the front panel downward, and
pull toward you (to release the catch
on the bottom). Push up to remove.
Step 2) Press the air filter assembly tab, pull
the air filter toward you, and remove.
Figure 1
Front panel
3. Removing the front casing assembly
Step 1) Remove the water tank and front
panel following the steps for sections
1 and 2 above.
Step 2) Remove front casing set screws (two
4x14, four 4x12).
Step 3) Pull the front casing assembly toward
you so that it is away from the main
unit.
Step 4) Pull the power board box toward you,
detach the catches on the box lid
(one on each side), and remove the
lid.
Step 5) Remove connectors P100 and P101
(connectors for main board
connection cable) from the power
board. Disassemble the front casing
assembly.
Repairable Control board
parts Tube temperature sensor
Picture 3
(Pic. 1)
(Fig. 1)
(Fig. 2)
Figure 2
(Pic. 2)
(Pic. 3)
(Pic. 4)
(Pic. 5)
Power board
Picture 4
Catch
Picture 1
Pre-filter
Even if the metal fins on the inside of
the unit become bent, this does not
affect performance.
Picture 2
Picture 5
Catch
Water tank
Sets special screw
(two 4x14)
Setscrew
(four 4x12)
Power board
connectors
P100/P101
33