Advertisement
Signal Cable MZ-80FC
(Back of MZ-80FB)
=
Signal Cable MZ-80FC
IN
OUT
liB'"
of
MZ-BOFBKI
@
Signal Cable MZ-80FCK
Signal Cable
MZ-80FC
MZ-80B
(Back of MZ-80FB)
Signal Cable MZ-80FCK
!
I
(Back of MZ-80FBK)
=
MZ-80FBK
MZ-80FB
I
'i~
O~IL--.J
0
Braided Wire
Remove the signal cable connected to the MZ-80FB signal
terminal. However, if connected to the I/O side, leave it as
it is.
2 Connect the signal cable that was removed as explained
above to the left-side signal terminal indicated by "IN"
on the back of the MZ-80FBK. Besides, firmly fix both
sides of the connector with the screws to fasten it. This
method is the same as that on page 3, section (2) and (3).
(Fasten screws in two places.)
3 First connect signal cable MZ-80FCK to the signal terminal
of the MZ-80FB. Use either cabie connector. Then, in the
same way as mentioned above, firmly fix both sides of the
connector with the suppl ied screws to fasten it. (Fasten
screws in two places.)
4 Connect the connector on the other end of signal cable
MZ-80FCK to the right-side signal terminal indicated by
"OUT" on the MZ-80FBK. Then, in the same way as men-
tioned above, firmly fix both sides of the connector with
the suppl ied screws to fasten it. (Fasten screws in two
places.)
5 Finally,
connect the braided wire between the FG
terminals of the MZ-80FB and the MZ-80FBK and also
connect a braided wire between the MZ-80B and the
MZ-80FBK as shown in the Fig. on the left.
5
Advertisement
