Advertisement
• ONLY connect the converter to a (professionally installed) wall socket with earth or
ground and the corresponding voltage setting, as indicated on the back. Any faulty
connection will invalidate the warranty.
• If it is necessary to replace the fuses, use only fuse(s) with the exact same value. The
fuse holders are positioned inside the amplifier and should only be replaced by an
authorized Van Medevoort Service Center. There are no user serviceable parts inside.
• The correct order for ON/OFF switching of the various products is as follows:
On: always first the source, then the pre-amplifier, followed by the power amplifier.
Off: always first the power amplifier, then the pre-amplifier, followed by the source.
• With the Q-Link connection switch ON the DAC first (to produce the MCK) and second
the transport.
• To prevent damage to your loudspeakers it is advisable, both at switching ON and OFF to
turn the volume control fully to the left. Fully anti-clockwise sets the volume at its lowest
level. The same applies when changing sources.
• Do make sure that there is always enough ventilation around the converter in order for it
to remain at its desirable temperature level.
•
Do not put any magnetic devices near or on top of the converter, e.g. floppy disks. This
can cause irreparable damage to such devices.
•
If you experience any problems, always contact your nearest authorized Van Medevoort
dealer or distributor.
4
vM DA468 STEREO DIGITAL / ANALOG CONVERTER
Controls
Precautions
Connections
Maintenance and advice
Technical Specifications
Advertisement
