Fujitsu FLASH-CAN-48P User Manual page 21

Select Crystal
Open Source
(MHX-File)
Start download
8. After programming the Flash-ROM, switch off the power supply and set back the mode
according to the usage of the application, e.g.:
Single-Chip
Run Mode
9. Power on the board. The user application is started directly.
Boot
4MHz
RUN
© Fujitsu Semiconductor Europe GmbH
FLASH-CAN-48P
Chapter 4 Programming the internal Flash
Set Device Type
MD0 MD1 MD2 nc
1 2 3
- 21 -
Select COM Port
nc nc P31 P30
P84 P83
4 5 6 7 8
RESET
ON
OFF
UART "A"
UG-900002-20