Advertisement
When drilling in wood or steel, shift knob to Rotation Only
and use
chuck adapter kit shown on page
2. To select rotary hammering, rotate the shift knob 180° in
the direction of the double arrow so that the tab portion of the
knob points toward the "Hammer" symbol.
NOTE: To engage the hammering mechanism, maintain
pressure on the bit. When pressure on the bit is released, the
hammering action will stop.
1.
2.
Using the Forward/Reverse Switch (Fig. 4 & Fig. 5)
1. For forward (clockwise) rotation, hold the tool with the
nose pointing away from you and push the forward/reverse
switch to the left. For the pistol grip hammer, hold the tool
with the nose pointing away from you and push the
forward/reverse switch to the left.
2. For reverse (counterclockwise) rotation, hold the tool with
the nose pointing away from you and push the
forward/reverse switch to the right. To prevent damage to the
Fig. 4
1.
1. Forward/Reverse Switch
RenTrain INC
Operating Instructions (continued)
3.
Fig. 3
1.Rotary Hammer Symbol
2. Drill Symbol
Fig. 5
Pistol Grip Tool
1. Forward/Reverse Switch
Tool is shown in forward
gears and motor, allow the tool to coast to a full stop before
reversing. For the pistol grip hammer, hold the tool with the
nose pointing away from you and push the forward/reverse
switch to the right. To prevent damage to the gears and
motor, allow the tool to coast to a full stop before reversing.
Starting, Stopping & Controlling Speed
1. To start the tool, pull the trigger.
2. To vary driving speed, simply increase or decrease pres-
sure on the trigger. The further the trigger is pulled, the
greater the speed.
3. To stop the tool, release the trigger.
Rotary Hammering (Fig 6.)
Position the tool, grasp the
handles firmly and pull the
trigger. Always use the side
handle. Hold the tool secure-
ly and maintain control. Use
only enough pressure to hold
the tool in place and to pre-
vent the tip of the bit from
wandering. This tool has
been designed to achieve top
performance with only mod-
erate pressure. Heavier pres-
sure will not significantly
increase the drilling rate and
it may overload the motor
and cause premature bit
wear.
If the speed begins to drop off when drilling deep holes, pull
the bit partially out of the hole while the tool is running to
help clear dust. Do not use water to settle the dust since it
will clog the bit flutes and tend to make the bit bind in the
Page 2
1.
1.
Fig. 6
Adapter
2.
Clean &
lubricate
threads
3.
Core Bit
Center
Pin
4.
5.
Guide
Plate
RenTrain INC
Advertisement
