Specifications
RF AERIAL INPUT 75 Ohm (unbalanced)
OPERATING VOLTAGE 220-240V AC, 50 Hz.
AUDIO OUTPUT POWER (W
POWER CONSUMPTION (W): 150 W (max) < 1 W
(Standby)
PANEL
16:9 display, 32" Screen Size
DxLxH (With foot): 212 x 788 x 567 Weight (Kg): 11,60
DxLxH (Without foot): 94 x 788 x 518,5 Weight (Kg): 10,90
Transmission Standards: VHF (BAND I/III) UHF (BAND
U) HYPERBAND
Step 2 - Control Touch Buttons
Step 3 - Connecting External Devices
Supported PC Input Typical Display Modes
The display has a maximum resolution of 1920 X 1080. Your TV may not support different resolutions. If you switch your
PC to an unsupported mode, a warning OSD will appear on the screen.
) (10% THD): 2 x 6
RMS.
You can adjust the volume or change channels using
and P/CH buttons on your TV.
Use TV/AV button to change sources.
Press
main menu.
English - 10 -
Step 1 - Installing the Batteries to the
Remote
1. Lift the cover on the back of the remote upward as
shown in the figure to the right.
2. Install two AAA batteries. Make sure to match the
+ and - ends of the batteries to the diagram in the battery
compartment.
3. Replace the cover.
+ and
- buttons at the same time to view the
Note: It is recommended that
the output resolution of a
connected device via the HDMI
input should be set to AUTO
(or original). If the connected
device does not include AUTO
(or original) resolution, selecting
576i for non-HD content is
recommended. If the connected
device does not include AUTO
(or original); or 576i options,
watcing non-HD content via the
Scart or Side AV connectors is
recommended.