Vizio L37 Service Manual page 51

7. Burst Read Operation
Burst Read operation in DDR SDRAM is in the same manner as the current SDRAM such
that the Burst read command is issued by asserting CS and CAS low while holding RAS
and WE high at the rising edge of the clock (CLK) after tRCD from the bank activation. The
address inputs determine the starting address for the Burst, The Mode Register sets type
of burst.
(Sequential or interleave) and burst length (2, 4, 8). The first output data is available after
the CAS Latency from the READ command, and the consecutive data are presented on
the falling and rising edge of Data Strobe (DQS) adopted by DDR SDRAM until the burst
length is completed.
8. Burst Write Operation
The Burst Write command is issued by having CS , CAS and WE low while holding RAS
high at the rising edge of the clock (CLK). The address inputs determine the starting
column address. There is no write latency relative to DQS required for burst write cycle.
The first data of a burst write cycle must be applied on the DQ pins tDS (Data-in setup time)
prior to data strobe edge enabled after tDQSS from the rising edge of the clock (CLK) that
the write command is issued. The remaining data inputs must be supplied on each
subsequent falling and rising edge of Data Strobe until the burst length is completed. When
the burst has been finished, any additional data supplied to the DQ pins will be ignored.
CONFIDENTIAL – DO NOT COPY Page 8-15
File No. SG-0176