Pentair Pool Products Pool Cleaner Installation And Operation Manual page 9

IMPORTANT: The eyeball diverter must fit snugly into the eyeball fitting. Some eyeball
fittings, like Aqua Leader or Olympic, may be too large for the eyeball diverter. In this situation,
use the outer ring supplied with your E-Z Vac to adjust for the discrepancy in size.
• Snap the outer ring onto the eyeball diverter and position it in the first groove as shown in
• Figure 11.
• Insert the eyeball diverter/outer ring assembly into the eyeball fitting in the return line.
• See Figure 11.
• Install the lock (retaining) ring and tighten.
Figure 11
Outer Ring
Eyeball Diverter Positions
• Make sure the opening of the eyeball diverter points to the side, at a "9 o'clock position," before
• tightening fully.
• Usually, directing the return line water flow against the side of the pool, as described above,
• works best. However, you may want to try pointing the flow downward or in different positions to
• see which works best in your pool.
NOTE: If the Eyeball or Eyeball with outer ring do not fit your pool, use the Wire Diverter
accessory available for purchase from your dealer.
After installing the eyeball diverter, turn the pool pump on. Your cleaner should begin moving
across the pool floor vacuuming up debris in its path.
Eyeball Diverter
Snap into this
Groove
9
Pool Deck
Eyeball
Fitting
Eyeball Diverter with
Outer Ring Attached
Lock
(Retaining)
Ring
Pool Wall
Return
Line