Fujitsu ScanSnap S500 Operator's Manual page 52

■ Turning the Scanner ON/OFF
ScanSnap is automatically turned on/off by performing the following actions:
•
Turn on/off the personal computer.
•
Open/close the paper chute of the scanner.
In general, you do not need to turn on/off the scanner when it is connected to your personal com-
puter.
Turn off your personal computer or close the paper chute.
The lamp on the scanner goes off and the scanner is turned off.
Turn on your personal computer or open the paper chute.
The lamp on the scanner lights up and the scanner is turned on.
To turn off the scanner when the paper chute is opened, press the [POWER] button on the scanner.
HINT
ATTENTION
34
When you turn on/off the scanner, press the [POWER] button for longer than
one second.
* To prevent unintended operation, the [POWER] button does not work unless it is
pressed for longer than one second.
•
Depending on your personal computer, the ScanSnap is initialized several
times while the personal computer is being started up.
•
It may take two to three minutes for turning off the lamp on the scanner
depending on your personal computer.
* This is related to the specification of the computer, not to malfunction of the
scanner.