Maintenance; Spare Parts - Husqvarna SpeedMill K750 Operator's Manual And Spare Parts List

MAINTENANCE:

Allow SpeedMill Bowls to cool before performing any main-
tenance.
NOTICE!
DO NOT hold SpeedMill Bowls using a screwdriver or
other device through the slots in the bowl. Damage to
the bowls or abrasive coating could occur.
DO NOT use a screw driver or similar in the slots of the
SpeedMill Bowls to lock the blade. If you do it is likely
the flanges will be damaged and become unusable.
Use the proper procedure to lock the blade when at-
taching or removing the blade or flanges – See below,
or see K750 Operation Manual.
Inspect the SpeedMill Bowls
Always inspect the SpeedMill Bowls before you start cut-
ting. Small nicks or scratches can be sanded smooth. If
the SpeedMill Bowl has been bent or distorted in any way it
must be replaced.
Cleaning
10 SpeedMill
MAINTENANCE
CAUTION!
When removing the Hub nut,
use a Screwdriver to lock the
blade shaft in position. Push
the screwdriver into the slot
(see picture) and rotate the ar-
bor until the screwdriver stops
the rotation.
Plastic debris from a small-
er flange often lodges itself
in the bigger flange during
cutting. This can easily be
removed once the flanges
have cooled down.
Use compressed air to
blow shavings from Speed-
Mill Bowl. DO NOT scrape
shavings from bowl using
a screwdriver or any other
hard metallic tool. Damage
to the bowls or abrasive
coating could occur.
CONVERTING THE SPEEDMILL TO A REGU-
LAR POWER CUTTER.
The guard on the SpeedMill is designed to work together
with the special outer flange and SpeedMill Bowls used
on the SpeedMill. The 8" (200mm) SpeedMill Bowl must
always be installed when the SpeedMill is used and the
SpeedMill shall not be used for any other purpose than
those mentioned in "USES" section (p7) of this document.
Should you desire to convert the SpeedMill to a regular
power cutter you must replace the cutting head with an
original 12" or 14" cutting head attachment. We recom-
mend you have an authorized dealer do the conversion.
NEVER use the SpeedMill as a regular power cutter!

SPARE PARTS:

The parts required for the SpeedMill Accessory are shown
on the next page. For any other parts used on this ma-
chine see the power cutter spare parts list (included).
WARNING!