Chute Assembly (If Equipped W/ 4-Way Chute Control) - Troy-Bilt Storm 3090XP Operator's Manaul

Chute Assembly (If Equipped w/ 4-Way Chute Control)

1. Remove cotter pin, wing nut and hex screw from chute
control head. Remove clevis pin and bow-tie cotter pin
from chute support bracket. See Figure 3-10.
Chute
Chute Base
2. Insert chute control rod into chute control head. Push rod
as far into chute control head as possible, keeping the
holes in the rod pointing upward. See Figure 3-11.
10 S 3— A
ection SSembly
Chute Control Head
Chute Support
Bracket
Figure 3-10
Figure 3-11
& S -U
et p
3. Place chute onto chute base and ensure chute control
rod is positioned under the handle panel. Install hex bolt
previously removed, but do not secure with wing nut at
this time. See Figure 3-12.
Figure 3-12
4. Squeeze the trigger on the joystick and rotate the chute by
hand to face forward. The holes in the chute control input
will be facing up. See Figure 3-13.
NOTE: The chute will not rotate without squeezing the
trigger on the joystick.
Chute Control
Input
Figure 3-13
Top View