Checking The Program Format; Adjusting The Audio Output Level - Dvd Level - Sony MEX-DV700 Operating Instructions Manual

1
During playback, press (AUDIO)
repeatedly until the desired audio
channel appears.
E.g., when playing an MP3
TRACK NAME
ALBUM NAME
ARTIST NAME
Note
You may not be able to change the audio setting
depending on the disc.
Tip
You can also change the settings of video discs by
selecting "AUDIO" in the play mode menu (page 21).

Checking the program format

You can check the number of channels and
component position on the DVD VIDEO being
played.
1
During playback, press
(VISUAL SETUP).
The play mode menu appears.
2
Press M/m to select
The program format appears.
Current audio format*
12 ( 67 )
018 ( 034 )
T 1:35:55
1:ENGLISH Dolby D
Current program format
* "PCM," "DOLBY DIGITAL," etc., appears depending
on the disc.
The letters in the program format display
represent the following sound components and
its position.
: Front (left)
: Front (right)
: Center
: Rear (left)
: Rear (right)
: Rear (monaural): The rear component of
the Dolby Surround processed signal and
the Dolby Digital signal
: Low Frequency Effect signal
24
Audio channel
MP3
0003/1000 ST
3:17 SHUF
(AUDIO).
PLAY
DVD VIDEO
PROGRAM FORMAT
DOLBY DIGITAL 3/2.1
L C R
LFE
LS RS
The program format name and channel numbers
appear as follow.
Example: Dolby Digital 5.1 ch
Rear component × 2
DOLBY DIGITAL 3 / 2 . 1
Front component × 2 +
Center component × 1
To hide the play mode menu, press
(VISUAL SETUP).
Adjusting the audio output level
— DVD level
You can adjust the audio output level for a DVD
recorded in Dolby Digital format, to reduce the
volume level differences between disc and
source.
1
During playback, press
(SYSTEM SETUP).
The system setup item appears on the main
unit.
2
Press M/m to select "DVD-LEVEL,"
then press (ENTER).
3
Press m to set to "ADJST-ON," then
press (ENTER).
4
Press M/m to select "DOLBY-ADJ,"
then press (ENTER).
5
Press M/m to adjust the output level.
The output level is adjustable in single steps,
between –10 and +10.
6
Press (ENTER).
The setting is complete.
To hide the system setup display, press
(SYSTEM SETUP).
With the main unit
Press and hold the control dial instead of pressing
(SYSTEM SETUP), rotate the control dial instead of
pressing M/m, press the control dial instead of
(ENTER).
LFE component × 1