Services Settings - Teleste MPH241 User Manual

The Real Time Streaming Protocol
(RTSP) ia a network protocol used to
establish and control media sessions
between devices. For example, a video
Decoder sends RTSP play command
to the video Encoder.
Note! If port clash is detected while
configuring RTSP server port, device
gives an error message and disables
RTSP server. After that you have to
give an unused (valid) port and enable
RTSP server again.
Session Announcement Protocol (SAP) is a
protocol for broadcasting multicast session
information. A SAP listening application can
listen to the SAP multicast IP address and
construct a guide of all advertised multicast
sessions (RFC 2974). SAP uses Session
Description Protocol (SDP) as the format of
the session descriptions. Announcement
data is sent using IP multicast and UDP.
Network Services
Enabled TLS versions
HTTP Digest Authentication
Session Announcement Protocol (SAP)
Announcement interval:
51

Services settings

Click "Services" under the Administration menu. Services Settings
page appears on the screen. This page allows you to enable/disable
different network services available and configure following parameters
of services:
_________________________________________________________
HTTP enabled: HTTP is always enabled.
HTTP port: Port 80 is used always.
HTTPS enabled: Enable/disable HTTPS.
HTTPS port: Configure HTTPS server port.
RTSP enabled: Enable/disable RTSP (Real time streaming protocol) server.
RTSP port: Configure RTSP server port.
_________________________________________________________
TLS 1.0: Enable/Disable Transport Layer Security protocol 1.0 (RFC 2246).
TLS 1.1:
Enable/Disable Transport Layer Security protocol 1.1 (RFC 4346).
TLS 1.2: Enable/Disable Transport Layer Security protocol 1.2 (RFC 5246).
_________________________________________________________
Enabled: Enable/Disable HTTP digest access authentication (RFC 2069).
Note! When is enabled, authentication is mandatory for all profile
based JPEG snapshot download.
_________________________________________________________
Enabled: Enable/Disable Session Announcement protocol (RFC 2974).
Multicast TTL: Multicast Time-To-Live for SAP packets (1...255).
SAP timing in seconds (1...999). Retransmit time of SAP-packet. This
time has to be same at both encoder and decoder pairs.
MPH200 series video encoders WebUI user manual