Warm Engine - Jonsered BC2125 Operator's Manual

Warm engine

Ignition: Set the stop switch to the start position.
Choke: Set the throttle to the start position by moving the
choke control to the choke position and then returning it to its
original position.
Air purge: Press the air purge diaphragm repeatedly until fuel
begins to fill the diaphragm. The diaphragm need not be
completely filled.
For throttle handles with a start throttle
lock:
Set the throttle to the start position by first pressing the throttle
lock and the throttle trigger, then pressing the start throttle
button (A). Then release the throttle lock and the throttle
trigger, followed by the start throttle button. The throttle
function is now activated. To return the engine to idle, press
the throttle lock and throttle trigger again.
Stopping
Stop the engine by switching off the ignition.
WARNING! When the engine is started with
!
the choke in either the choke or start throttle
positions the cutting attachment will start to
rotate immediately.
20 –
English
STARTING AND STOPPING
Starting
Hold the body of the machine on the ground using your left
hand (CAUTION! Not with your foot!). Grip the starter handle,
slowly pull out the cord with your right hand until you feel
some resistance (the starter pawls grip), now quickly and
powerfully pull the cord. Never twist the starter cord around
your hand.
Repeat pulling the cord until the engine starts. When the
engine starts. return choke control to run position and apply
full throttle; the throttle will automatically disengage from the
start setting.
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.