Table of Contents
Advertisement
Installation
Installation
Choose a location for Lynx
When installing the Home Dock in your home, choose a location in close proximity to your stereo system or powered
speakers, and also where the cable from the Indoor/Outdoor Home Antenna can reach the Home Dock. The location
should be easily accessible and provide good visibility of the display, but should not be located where it will be in direct
sunlight, which will affect the visibility of the display screen.
You will also need to decide whether you will be connecting your Home Dock to your stereo system using the provided
Stereo Audio Cable, or directly to a set of powered speakers.
Some other factors to consider when installing your Home Dock, and are planning to use your Lynx in handheld mode:
•
You will need to stay within range of your Wi-Fi network. Wi-Fi reception can vary depending upon the signal
strength of the Wi-Fi network, and the physical surroundings.
•
Bluetooth
range is approximately 30 feet, but can vary depending upon the physical surroundings.
Connect the Home Dock
Make the connections to the Home Dock as follows:
1. Connect the Home Power Adapter to the red POWER connector at the rear of the dock, and plug it into an
outlet.
2. Connect the Indoor/Outdoor Home Antenna to the silver ANT connector at the rear of the dock.
3. Place Lynx into the Home Dock. Orient Lynx so that it is parallel to the backrest, and then gently slide it down
until it is seated.
6
Advertisement
Table of Contents
