Iomega 3798300 Owner's Manual page 37

Jumper block
Slave (Drive 1)
(Factory Setting)
Master (Drive 0)
Slave (Drive 1)
Use this setting if you're connecting the Zip
your CD drive or another ATAPI device that is configured as the master.
Master (Drive 0)
Use this setting if you're connecting the Zip
the secondary IDE channel or when installing to an IDE add-on card. Use the
jumper provided when configuring the drive to the "Master" setting.
Cable Select
Use this jumper setting if your computer features "Cable Select." On a
Cable Select system, the master/slave configuration is automatically determined by
the system. Contact the computer manufacturer if you need additional information.
Use the jumper provided when configuring the drive to the "Cable Select" setting.
Possible System IDE/ATAPI Configurations
Your computer may be configured in one of the following ways. If you
need to change the jumper settings for your CD drive, check its
documentation to see how to configure it as master or slave as needed.
(Alternative)
Master
Device
Slave
Device
BIOS/CMOS Support
BIOS support for the Zip
Setup. If your system includes autodetection, it should be turned off for
the Zip Internal drive.
Zip Internal drive
(Recommended)
Primary IDE
Master
Hard Drive
Device
Slave
Device
Primary IDE
Secondary IDE
Channel
Channel
Zip ATAPI
Hard Drive
Drive
CD drive
®
Internal drive should be disabled in the CMOS
Cable Select
Reserved
(do not use)
®
Internal drive on the same cable as
®
Internal drive as the only device on
Secondary IDE
Channel
Channel
CD drive
Zip ATAPI
Drive
(Alternative)
Primary IDE
Channel
Master
Hard Drive
Device
Slave
Device
Secondary IDE
Channel
Zip ATAPI
Drive
CD drive
37