Iomega 3798300 Owner's Manual page 28

®
Ejecting Zip Disks
Windows 95/98 systems:
Windows NT systems:
command.
Windows 3.1 systems:
When your Zip
remove the Zip
Disk Eject in Case of Power Loss
The computer must be powered on for normal disk insertion and removal.
If you need to eject a Zip
Zip drive and push a straightened paper clip into the emergency eject hole
which is located just above the power connector (see illustration below).
CAUTION
emergency disk eject hole. Do not try to forcibly remove a Zip
from the drive. If the disk does not eject immediately, repeat the
emergency disk eject procedure as described above.
Drive Sleep
®
The Zip Internal drive has an automatic sleep mode that spins down a
Zip ® disk after 15 minutes of inactivity. This feature minimizes power
consumption when the Zip drive is not being accessed. The Zip disk
automatically spins up again when the drive is accessed.
You can use the Iomega Tools program included with your drive to change
the drive sleep setting. Refer to the Iomega Tools help file included in your
software package for additional information.
Windows 3.1 or Windows NT 3.51 users
Tools help file included in your software package for instructions.
28
Push the disk eject button or use the Iomega
software eject command.
Push the disk eject button.
®
drive is not in use, remove the disk from the drive. Always
®
disk before moving your computer.
®
disk during a power failure, access the rear of the
Disconnect power from the computer before using the
Emergency Eject Hole
Use the Iomega software eject
- See the Iomega
® disk