Adjust Handset Rest - Cisco 8961 Features

Unified ip phone

Hide thumbs Also See for 8961:

Administration manual (378 pages)

User manual (180 pages)

Overview (30 pages)

Table Of Contents

Table of Contents

Clean Phone Display

If your phone is active (for example, on a call), your phone waits until it has been inactive for a period of time

before telling you of the pending power shutdown. Before the shutdown happens, you see a message to remind

you that your phone is about to power off.

After your phone goes to sleep, press Select to wake up your phone. After the phone is inactive for a period

of time, a message displays to alert you that the phone is about to power down. At the configured wake time,

your phone powers up.

Wake and sleep times are also linked to the configured days that you normally work. If your requirements

change (for example, your work hours or work days change), contact your system administrator to have your

phone reconfigured.

For more information about EnergyWise and your phone, contact your system administrator.

Clean Phone Display

When the phone is in sleep mode, the touchscreen is blank and the Select button is not lit. When the phone

is in this condition, you can clean the screen, as long as you know that the phone will remain asleep until after

you finish cleaning. If the phone is likely to wake up during cleaning, wake it up or wait until it is awake

before following the preceding cleaning instructions.

Use only a soft, dry cloth to wipe the phone display. Do not use any liquids or powders on the phone

Caution

because they can contaminate phone components and cause failures.

Procedure

Step 1

Before cleaning the phone display, press Select until you see the message Touchscreen Disabled to

disable the phone screen.

The phone screen reenables automatically after 60 seconds.

Step 2

To reenable the phone screen manually after cleaning, press Select until you see the message Touchscreen

Enabled.