Cg Tilt Power Accessory; Lift Power Accessory; Power Recline; Set Up, Adjustment & Use - Sunrise Medical R3/F3 User Instruction Manual

26 V I I . W a r n i n g s : C o m p o n e n t s & O p t i o n s
aware of their surroundings while components are in motion.
6. Maximum User Weight
Do not exceed the weight capacity for your specific chair/seating system config-
uration. Doing so could result in premature failure or injury.
N. CG TILT POWER ACCESSORY
The powered CG Tilt accessory for the Groove has a maximum user weight capacity
of up to 400 lbs. Never exceed this capacity while operating the powered actuator.
O. LIFT POWER ACCESSORY
The powered lift accessory for the Groove has a maximum user weight capacity of
up to 400 lbs. Never exceed this capacity while operating the powered actuator.
P. POWER RECLINE
Pinch Point
Avoid putting hands or fingers near the rotary recline mechanism while in operation.
Weight Capacity
The maximum user weight capacity for the rotary recline mechanism is up to 250 lbs.
Exceeding this weight capacity could lead to injury and/or permanent damage to the
equipment.
932208 Rev. A
V I I I . S e t - U p , A d j u s t m e n t & U s e

NOTES

1. Work Surface For Set-Up:
Use a flat surface, such as a table, to assemble, adjust and check your chair.
This makes the steps easier and helps ensure a correct set-up.
2. Fasteners:
• Many of the screws and bolts on this chair are special high-strength fasteners
and may have special coatings.
• Many nuts are of the Nylock type. They have a plastic insert to help prevent
loosening.
• Only use screws, bolts and nuts provided by Sunrise.
1. Use of improper fasteners may cause the chair to fail.
2. Over- or under-tightened fasteners may fail or cause damage to chair parts.
3. If bolts or screws become loose,tighten them as soon as you can. Loose
bolts or screws can cause damage to other chair parts causing them to fail.
3. Washers & Spacers:
• Note the position of washers and spacers before disassembly.
• To avoid damage to the frame, replace all washers and spacers when you
reassemble parts.
4. Torque Settings:
• A torque setting is the optimal tightening for a particular fastener. Use a torque
wrench that measures inch-pounds to secure screws, nuts and bolts on this
chair.

TOOLS YOU WILL NEED

1. Basic Tool Kit:
To set-up, adjust and maintain your chair you may need the following tools:
• Combined Phillips and flat screw driver
• Standard metric wrenches from 8mm - 14mm
• Metric Allen wrenches from 2mm - 8mm
• Imperial wrenches from 1/4" to 9/16"
• Imperial Allen wrenches from 5/64" to 1/4"
You can obtain a multi-purpose tool kit from Sunrise, or buy the tools you need from a
hardware store.
2. Torque Wrench:
If you plan to adjust and maintain this chair yourself, Quickie recommends that you
use a torque wrench.
Q-NOTE– The wrench must measure inch-pounds (N.m). You can buy a torque
wrench and proper sockets from a hardware store.
27
932208 Rev. A