Baby Lock BL J18-QM Installation Manual page 8

Fig. 1-J
Power Strip
Brackets
M4 x 10mm
Hex Bolt
Fig. 1-L
1-8 . Turn your carriage onto its side and attach
the four (4) Motor Plate Brackets onto the
QuiltMotion plate using the four (4) M4 x 14mm
Phillips Head Screws. Insert the M4 x 14mm
Phillips Head Screws from the underneath side of
the carriage, as shown in Fig. 1-J, and 1-K.
Fig. 1-K
1-9 . Next, you will install the Power Strip to the
Power Strip Bracket on your carriage as shown in
Fig. 1-L and 1-M. Turn your carriage upside down
again and return to the end of your carriage with
the Power Strip Brackets. Thread two (2) M6 x
10mm Hex Bolts through the slots of the Power
Strip and into the threaded holes of the Power
Strip Brackets. Tighten these completely.
Power Strip
Fig. 1-M
Pg. 7