Table of Contents
Advertisement
Configuration Program Controls
Create Keys Manually:
Once you set the Encryption type as 64 bit or
128 bit, you may choose to edit WEP keys
manually or create them via the passphrase of
your wireless network. If you choose the
Create Keys Manually option, you may
directly enter up to 4 WEP keys for use in WEP
encryption. To generate the WEP keys, please
define the key entry method as Alphanumeric
or Hexadecimal (for hexadecimal characters,
only digits 0-9 and letters A-F are valid). Then
edit the texts in the blank fields below, from
Key 1 to Key 4, as the encryption codes. Note
that these codes/keys shall be identical
between the wireless nodes within the range
and the access point only. Check the table right
to find valid key length of each encryption type:
Use WEP Key:
Indicate which WEP key you intend to apply
to activate the WEP encryption from the pull-
down menu. Make sure that the intended
access point on the wireless network shares
the same keys. By default, Key 1 will be
used.
Create Keys with Passphrase:
Choose this command when the associated
wireless network uses a passphrase to
create WEP keys. Enter the passphrase
34
Advertisement
Table of Contents
