Eureka AS5210 Series Owner's Manual page 7

How to maintain your vacuum cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged.
Maintain brush roll
Motor pulley can become hot with normal use.
Remove hair and threads from brush roll periodically. Do not remove end caps.
Check belt. Replace if worn, cut or out of shape.
Avoid touching the motor shaft when checking brush roll or belt.
How to replace belt
• Step on brush roll pedal to turn brush roll
to OFF position (Fig.1).
• Remove 4 screws from brush roll cover
(Fig. 2).
• Lift off brush roll cover (Fig. 3).
• Remove brush roll and belt. Feed new belt
between two metal pins and push through
frame (Fig. 4).
• Loop belt around motor stem (Fig. 5).
• Insert left end of brush roll first. Make sure
end cap fits into base. Loop the belt
around the right side of brush roll and
insert right end cap into base (Fig. 6).
Make sure it slides into position.
• Press the brush roll ON/OFF pedal to
compress the belt slightly (Fig. 7).
• Rotate brush roll 2 turns to center belt
(Fig. 8).
• Replace brush roll cover (Fig. 9).
• Replace 4 screws (Fig. 10).
Eureka Customer Service HELPLINE 1-800-282-2886
Fig.1
Fig. 3
Loop around
motor stem
Fig. 5
Fig. 7
Fig. 9
Fig. 2
Feed between
2 pins
Fig. 4
L
Fig. 6
Fig. 8
Fig. 10
www.eureka.com
R
5