How To Install; Install Washing Machine Horizontally - Panasonic NA-F90T1 Operating Instructions Manual

How to install

Placement
• Do not install the washing machine in any extremely damp place such as a bathroom, or in a place
exposed to the weather. There is a danger of electric shock, fi re, machine trouble and deformation of
machine.
• If machine is installed on the fl oor, be sure that carpet does not block any openings to prevent it from
closing any ventilation openings.
• Do not install the washing machine exposed to direct sunlight (This could cause machine trouble,
deformation and other problem.)
Power cord
• Make sure to push the power plug completely into the socket outlet. If the power plug
is not completely pushed into the outlet, this will cause electric shock and fi re due to
overheating.
Establish a ground (In case of two-wire power cords)
• When there is a grounding receptacle on power supply
outlet.
• When carbon ground rod (sold separately) is used.
• Do not connect to gas pipe, water pipe, or ground wire
of telephone or lighting rod.
• Reestablish a ground when you change installation
location or move.
• For further information, contact the distributor or service
technician.

Install Washing Machine Horizontally

1
Place the washing machine on a fl at and secure location.
2
Open the lid, leveller is already fi x on the Plastic Body surface. Visually check
that the bubble of the leveller is inside the mark from the front and top.
When the bubble is inside the mark
Mark
3
Adjust height
When the bubble is largely out of mark
• The fl oor is largely inclined against the
direction that the bubble is leaning.
• Let the bubble inside the mark by
placing a board under the leg on
the other side.
When the bubble is a little out of mark
4
Check the machine for unsteadiness and tightens the adjustable leg knob.
NA-F90T1 80T1_EN.indd 19 NA-F90T1 80T1_EN.indd 19
• There is no need
to make a height
Bubble
adjustment.
Board or a like
Front side
Adjust using
adjustable leg
(Bottom view)
Socket outlet
WARNING
Make sure to establish a ground.
There is a risk of electric shock
caused by a leakage of electricity.
Grounding
receptacle
Ground
wire
Leveller
Plastic Body
1. Turn the Adjustable Leg Knob towards
(LOOSEN) direction to loose it.
2. Turn the Adjustable Leg to adjust the levelness.
• When increasing height, turn Adjustable
Leg towards (LOOSEN) direction.
• When decreasing height, turn Adjustable
Leg towards (TIGHTEN) direction.
3. Turn the Adjustable Leg knob towards
(TIGHTEN) direction to tighten it.
Adjustable leg knob
Loosen
Adjustable leg
To raise
Carbon
ground
Tighten
To lower
19
9/17/08 9:45:43 AM 9/17/08 9:45:43 AM