Indicators - Mitsubishi Electric XL8U User Manual

Indicators

This projector has two indicators, each of which shows the operation condition of the projector.
The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your
dealer.
Normal condition
POWER
STATUS
Steady
Off
red
Blinking
Steady
green
green
Steady
Steady
green
green
Abnormal condition
POWER STATUS CONDITION
Abnormal temperature
• The ventilation grilles or air filter is clogged with
Steady
green
• The room temperature is high.
or
Blinking orange
Steady red
The protection circuit is working or the lamp is in an
abnormal condition.
Steady red
Blinking green
Lamp operation time warning. (Total lamp operation
Steady time reached 1,500 hours* while the power was on.)
Blinking green/red
green
Lamp operation time warning. (Total lamp operation
time reached 1,500 hours* while the power was off.)
Steady red Blinking red
Lamp operation time warning. (Total lamp operation
time reached 2,000 hours* while the power was off.)
Steady red
Steady red
The lamp cover isn't closed.
Off
Blinking
green/red
Abnormal.
Steady
or
Blinking
green/red
Blinking
* When LAMP MODE of the INSTALLATION menu is set to STANDARD.When it is set to LOW, the duration will be extended.
POWER indicator
POWER STATUS
AUTO POSITION
COMPUTER KEYSTONE
CONDITION
Stand-by
Lamp stand-by (about 1 minute)
The power is on. (Normal condition)
dust or dirt.
STATUS indicator
VIDEO
POSSIBLE SOLUTION
• Clean the ventilation grilles or air filter.
• Relocate the projector to a cooler place.
• Wait until the STATUS indicator goes out,
• If the above solution is not effective,
Replace the lamp.
Change with a new lamp if this problem
recurs.
Close the cover correctly.
Contact your dealer.
NOTE
The POWER button cannot be used to
switch between on and off.
then press the POWER button.
replace the lamp.
EN – 29