Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - Husqvarna 338XPT EPA III Operator's Manual

Symbols on the mac hine:
W ARNING! Chain saws can be dangerous!
Careless or improper use can result in serious or
fatal injury to the operator or others.
Please read the operator's manual carefully and
make sure you understand the instructions
before using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ' s hands must be used to
operate the chain saw.
Never operate a chain saw holding it with one
hand only.
Never let the guide bar tip come in contact with
any object.
WARNING! Kickback may occur when the
nose or tip of the guide bar touches an object,
and cause a lightning fast reverse reaction,
kicking the guide bar up and towards the
operator. May cause serious personal injury.
Recommended cutting
equipment in this example:
- Bar length 14 inches
- Max. nose radius 7 Teeth
- Chain type Husqvarna H36
Other approved bar and chain combinations in
Operator's Manual.
Measured maximum kickback value without
triggering the brake, for the bar and chain
combination on the label.
Other symbols/decals on the mac hine refer to
special certification requirements for certain markets.
Symbols in the operator' s manual:
Switch off the engine b y moving the stop switch
to the STOP position before carrying out any
checks or maintenance.
Working position
Choke
Always wear approved protective gloves.
2 –
Canadian
KEY T O SYMBOLS
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be worn.
Refuelling.
Filing with oil and adjusting oil flow.
The chain brake should be activated when
starting.
WARNING! Kickback may occur when the
nose or tip of the guide bar touches an object,
and cause a lightning fast reverse reaction,
kicking the guide bar up and towards the
operator. May cause serious personal injury.
Y ou will find the following labels on your chain saw:
EPA III
The Emissions Compliance P eriod referred to on the
Emission Compliance label indicates the number of operating
hours for which the engine has been shown to meet Federal
and Californian emissions requirements.
Maintenance, replacement, or repair of the emission control
devices and system may be performed by any nonroad
engine repair establishment or individual.
The engine exhaust from this product
contains chemical known to the State
of California to cause cancer, birth
defects or other reproductive harm.