IOGear MINIVIEW GCS1762 User Manual page 29

Hotkey Operation
Note: This procedure is a toggle. To re-enable the keys, repeat the procedure above.
Firmware Upgrade Mode
To set the GCS1762/GCS1764 in firmware upgrade mode:
1. Invoke HSM
2. Key in: upgrade
3. Press [Enter]
Note: The front panel LEDs will flash to indicate that the KVM is in firmware upgrade mode. To exit firmware
upgrade mode, you must power off the switch.
Restore Default Settings
To reset the GCS1762/GCS1764 to its factory default settings, do the following:
1. Invoke HSM
2. Press [R] [Enter]
All hotkey settings return to factory default.
26