Before The 1St Washing - Siemens WM14Y890GB Instruction Manual And Installation Instructions

Before the 1st washing

The washing machine was inspected thoroughly before leaving
the factory. To remove any water left over from testing
procedures, the first washing cycle should be carried out without
laundry in the machine.
²
The washing machine must have been installed and connected
properly. See chapter Installing ~ Page 65
1.
²
Never switch on a damaged machine. Inform your customer
service. ~ Page 52
2.
3.
4.
5.
6.
7.
8.
9.
10.
Your washing machine is now ready for use. Your washing machine is now ready for use. Your washing machine is now ready for use.
68
Check the machine.
ô
Fill dispensers
Remove protective film from the fascia. Remove protective film from the fascia. Remove protective film from the fascia.
Insert mains plug.
Turn the tap on.
Switch on the appliance.
Close the washing machine door. Do not load any washing. Close the washing machine door. Do not load any washing. Close the washing machine door. Do not load any washing.
To prevent unused detergent from flowing into the outlet To prevent unused detergent from flowing into the outlet To prevent unused detergent from flowing into the outlet
during the first wash: Pour 1 litre of water into dispenser during the first wash: Pour 1 litre of water into dispenser during the first wash: Pour 1 litre of water into dispenser
and start the Drain programme. Drain Drain
Select and start the Select and start the Select and start the Cotton 90 °C programme.
When the programme ends, switch off the appliance. When the programme ends, switch off the appliance. When the programme ends, switch off the appliance.
M ô
. ~ Page 34
/ Page 34 Page 34
programme. programme.
À Á