Table of Contents
Advertisement
Before the 1st washing
The washing machine was inspected thoroughly before leaving
the factory. To remove any water left over from testing
procedures, the first washing cycle should be carried out without
laundry in the machine.
The washing machine must have been installed and connected
²
properly. See chapter Installing ~ Page 61
Check the machine.
1.
Never switch on a damaged machine. Inform your customer
²
service. ~ Page 50
Fill dispensers
2.
Remove protective film from the fascia.
3.
Insert mains plug.
4.
Turn the tap on.
5.
Switch on the appliance.
6.
Close the washing machine door. Do not load any washing.
7.
To prevent unused detergent from flowing into the outlet
8.
during the first wash: Pour 1 litre of water into dispenser
and start the Drain programme.
Select and start the Cotton 90 °C programme.
9.
When the programme ends, switch off the appliance.
10.
Your washing machine is now ready for use.
/
.
M ô
ô
À Á
63
Advertisement
Table of Contents
