Ø Information On The Display Panel - Siemens WM14Y890GB Instruction Manual And Installation Instructions

Information on the display panel
Display
The door cannot be
locked, please open
the door again, then
close it and select
"start/pause".
Please re-fill
i ô ô
i-Dos I , i-Dos
container
ô ô
i
i-Dos I , i-Dos
error; deactivate
ô ô
i
i-Dos I , i-Dos
Please close
detergent drawer.
Please open tap
Please clean pump Please clean pump Please clean pump
Pause: Reload is not
possible
Door cannot be
unlocked: Water
level or temperature
is too high
aquaStop has been
activated!
Please call customer
service
Auto power-off in ...
seconds,
Water cooling
Other displays
Error E: XXX
Cause/Remedy
– Washing may be caught. Please open and close washing
machine door again and select Start/Pause
– If required, shut washing machine door or remove washing and
shut again.
– If required, switch appliance off and on again; set programme
and make individual settings; start programme.
Level i-Dos container below minimum, Top up ~ Page 34
ô
i
Set i-Dos I , i-Dos
Call customer Service. Appliance can continue to be operated with Call customer Service. Appliance can continue to be operated with Call customer Service. Appliance can continue to be operated with
manual dosage. ~ Page 38
Push in detergent drawer correctly. ~ Page 34
Push in detergent drawer correctly. Push in detergent drawer correctly.
– Turn on tap fully.
– Supply hose kinked/jammed. – Supply hose kinked/jammed. – Supply hose kinked/jammed.
– Water pressure too low. Clean the filter. ~ Page 47
– Water pressure too low. Clean the filter. – Water pressure too low. Clean the filter.
– Drain pump blocked. Clean the drain pump. – Drain pump blocked. Clean the drain pump. – Drain pump blocked. Clean the drain pump.
– The water drainage pipe/drain hose is blocked. Clean the – The water drainage pipe/drain hose is blocked. Clean the – The water drainage pipe/drain hose is blocked. Clean the
drainage hose on the siphon. ~ Page 46
drainage hose on the siphon. drainage hose on the siphon.
Water level or temperature is too high. Water level or temperature is too high. Water level or temperature is too high.
Select Select Start/Pause Select /Pause
Start Start/Pause
Water level or temperature is too high. Water level or temperature is too high. Water level or temperature is too high.
Select Start/Pause Select Select
not applicable without Aqua-Stop
Water in the base pan, appliance leaking.
Call customer service! ~ Page 52
Appliance automatically switches off after ... seconds if it is not
operated for a prolonged period. In order to cancel the
programme, press any button. ~ Page 40
To protect the wastewater pipes, the hot detergent solution is
cooled before being drained.
Switch off appliance, wait 5 seconds and switch on again. If the
display is indicated again, call customer service. ~ Page 52
ô
to off.
~ ~
Ü
to continue the programme.
Ü
to continue the programme.
Ü
.
49