a
ssembly
Tools Required: 10 x 19 mm T-Wrench, 4 mm Hexagonal Wrench
Parts Required: Power Head/Shaft Tube Assembly,
Cutting Attachment
cuttIng attachment to shaft tube InstallatIon
WARNING
Saw Chain is sharp! Always wear gloves when handling assembly,
otherwise serious personal injury may result.
1. Loosen the four (4) bolts and remove locater bolt on cutting attach-
ment.
2. Loosen center clamp knob turning anticlockwise.
3. Pull upper shaft tube out of fiberglass lower shaft tube 130 to 150
mm, then slide back upper shaft tube into fiberglass lower shaft
tube exposing inner power transmission shaft. Align and join star
shaped drive end of inner power transmission shaft with cutting
attachment shaft.
4. Align ridges on upper shaft tube with seams in cutting attachment.
5. Slide together aligning locater bolt in cutting attachment with
locating hole in upper shaft tube.
6. Install and tighten locater bolt. Tighten four (4) cutting attachment
bolts.
7. Extend upper shaft tube to desired length. Tighten center clamp
knob turning clockwise.
P
P
ower
runer ™
o
M
Perator ' s
anual
Four bolts
Locater bolt
Clamp knob
Transmission shaft
Upper shaft tube
Clamp knob
Upper shaft tube
Transmission shaft
Attachment shaft
Locater bolt
Four bolts
13
Locating
hole