Advertisement
If CCT is at any value other than 0 and the Color Mode is any setting other than None, the instrument will
ignore the color channels and only create white light. Moving the CCT channel to 0 will bump the instrument to
wherever the color channels are set.
If the Correction option is selected, a channel will be added following the CCT channel that allows for the
adjustment of green and magenta in the CCT output. The Correction channel should be defaulted to 50%
(127) for no correction. Raising the Correction channel will add up to 5 units of green. While lowering the
Correction channel will add up to 5 units of magenta. This feature is important of the user is attempting to
balance to sources that may have color shift towards green or magenta, such has fluorescents or only white LED
devices.
If using the Correction option, ensure that Color is selected for the Algorithm found in Advanced Settings.
If enabled, in 8 bit mode 1 channel will be added after the color channels, 2 channels will be added if 16 bit
control is being used.
If Correction is selected, in 8 bit mode 2 channels will be added after the color channels, 4 channels will be
added if 16 bit control is being used. CCT channel(s) then Correction channel(s).
Intensity
Available Options: Linear, Standard
Users may select either from a linear dimming curve or square law dimming. Square law dimming is frequently
used in television production with the low end and top end of the dimming curve are smoothed out.
RevEAL instruments always use an intensity channel, in 16 bit operation 2 channels are used.
Full and Eco Power Modes
Available Options: Full Power, Remote, ECO
Full Power
With Full Power Selected the instrument will use all active cooling including the fan and operate at the highest
lumen output of approximately 9700 lumens.
Remote
If Remote is selected a control channel will added at the beginning of the DMX address block. At full this
channel will turn off the fan, output of the instrument will be diminished. The amount that output will be
diminished is dependent on the color being produced. In general it is between 40-50%. A value other than full
will put the fixture in full power mode.
ECO
ECO mode turns off the fan and the instrument will operate virtually silently, with diminished output. ECO
mode will run the instrument with incredibly high efficiency. The total wattage draw of the instrument will be
significantly reduced by 50% and the lumen output will be reduced 40%.
12
Advertisement
