Wireless Headphones; Screen Settings; Battery Installation - Alpine PKG-RSE3DVD Quick Start Manual

Screen Settings

SETUP
PICTURE
Screen Mode
TV System
Screen Name
Remote Control
Setting the Screen Mode and TV System
Display mode on the screen can be adjusted to Wide,
Cinema or Normal. (Default: WIDE)
• Press or to select WIDE/CINEMA/NORMAL
The Video Signal Standard (TV System) can be
manually switched.
• Press or
to select AUTO/NTSC/PAL.
( )
Default: AUTO
System Setting
The IR transmitter, FM modulator and frequency can be adjusted
for all available sources.
SETUP
PICTURE
Setting the IR Transmitter
Press or to select A/B/OFF. (Default: A)
CHANNEL A : 2.3 MHz/ 2.8 MHz
CHANNEL B : 3.2 MHz/ 3.8 MHz
Setting the FM Modulator
Press or to select FM Radio region
(OFF/USA/OTHERS). (Default: OFF)
Setting the FM Frequency
Press or to select desired FM Radio
Frequencies between 88.1 MHz to 92.1 MHz.
(Default: 89.1 MHz)
USA frequency step is 0.2MHz and other countries is 0.1MHz.
Resetting to the Factory Default
Press ENTER Key, the system changes to Factory
Default System Setting. Entire settings include
Picture, Picture Mode, Display Mode are also reset.
DVD Setup values will not be affected.
6
-EN
SCREEN SYSTEM
WIDE
AUTO
AUX1
OFF
SYSTEM
SCREEN
IR Transmitter B
FM Transmitter
OFF
--.- MHz
FM Frequency
Factory Reset

Wireless Headphones

Headphone Receivers
1) Battery Cover
2) Volume Control
3) Power Switch
4) Power Indicator LED
Operation
Read carefully to prevent damage to the headphone or
your ears:
WARNING: Before turning on the power, remove headphones and turn
the volume down as low as possible.
1) Be sure the batteries are properly installed in the
headphones.
2) Turn the headphones volume completely down before
placing it on your ears and turning on the power.
3) Turn on the headphone power and adjust the
headphone volume to a comfortable level (You can
increase the audio source volume if needed).

Battery Installation

Place two AAA batteries into the battery compartment of the
headphone(s), making sure that the battery polarity is correct.
Note
If ACC or the monitor's power source is turned off,
a loud noise is produced through the headphones.
Be sure to remove the wireless headphones from
your ears before you turn the monitor off.