Surround Display Feature; Jumpers Setup - ASROCK P55 Extreme User Manual

2.9 Surround Display Feature

2.9 Surround Display Feature 2.9 Surround Display Feature
2.9 Surround Display Feature 2.9 Surround Display Feature
This motherboard supports Surround Display upgrade. With the external add-on
PCI Express VGA cards, you can easily enjoy the benefits of Surround Display
feature. For the detailed instruction, please refer to the document at the following
path in the Support CD:
..\ Surround Display Information

2.10 Jumpers Setup

2.10 Jumpers Setup 2.10 Jumpers Setup 2.10 Jumpers Setup 2.10 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose pin1
and pin2 are "Short" when jumper cap is placed
on these 2 pins.
Jumper
PS2_USB_PWR1
1_2
(see p.12, No. 1)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
Clear CMOS Jumper
(CLRCMOS1)
(see p.12, No. 13)
Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord from the power supply.
After waiting for 15 seconds, use a jumper cap to short pin2 and pin3 on CLRCMOS1
for 5 seconds. However, please do not clear the CMOS right after you update the
BIOS. If you need to clear the CMOS when you just finish updating the BIOS, you
must boot up the system first, and then shut it down before you do the clear-
CMOS action.
Setting
2_3
+5V
+5VSB
1_2 2_3
Default Clear CMOS
3 0 3 0 3 0
3 0 3 0
Description
Short pin2, pin3 to enable
+5VSB (standby) for PS/2
or USB wake up events.