Save A Service Call - Solahart 10143200 Owner's Manual

Check the items below before making a service call. You will be charged for attending to any condition
or fault, which is not related to manufacture or failure of a part (refer to
COLD WATER FROM THE HOT TAP
•
Close the hot tap, wait 10 seconds and open the hot tap again.
•
Is the hot tap open enough?
The burners will not light if the flow rate is less than
3 L / min.
•
Is the power supply cord is plugged in and the power outlet
switched on?
•
Is power available in the house?
Try using another electrical appliance.
•
Is the isolation valve in the gas line open?
•
Is there a gas supply to the rest of the house?
Try lighting another gas appliance.
•
Has the gas line been purged of air after installation?
Refer to your plumber.
NO WATER FROM THE HOT TAP
No flow of water from the hot tap may indicate a restriction in or failure of the cold water supply to the
water heater. Check for water flow at other taps and that the cold water isolation valve
page 23) are fully open.
WATER FLOW FLUCTUATES
More than two or three hot taps in use at the same time may cause a decrease in the hot water flow
from the taps if the gas booster water heater is operating and the solar preheat water is at a low
temperature.
•
Are there more than two or three hot taps open, or are appliances such as a dishwasher or
washing machine, in use at the same time?
Ensure only two or three hot taps (or appliance) are on at the one time.
•
Check the flow of the water from one tap, eg, the shower.
The shower should be adjusted so the hot tap is fully open.

SAVE A SERVICE CALL

10
"Warranty" on page 38).
(refer to