Connecting Analog Cables; Setting The Camera Dip Switches - UTC 1070140-EN User Manual

Alarm output
Type
Connector type

Connecting analog cables

Connect a standard CCTV monitor to the system to adjust the quality of the video
image using the DIP switches. The DIP switches can also be adjusted when
connected to the IP system.
To connect the cables:
1. Connect a coaxial cable from the camera's BNC connector to a CCTV
monitor or video recording device.
2. Connect a PoE switch, a 12 VDC or 24 VAC power supply to the power input.
Do not connect both the PoE connection and DC or AC connection at the
same time. The label on the camera gives the following information:
Red cable. Power in.
Black cable. Power in.
White cable. Video out.
Black cable. Video ground.
Note: For 24 VAC or 12 VDC, Black or Red may be used for ground.

Setting the camera DIP switches

You can set up six camera functions using the DIP switch bank on the rear of the
camera. Figure 4 below shows the DIP switch layout. See "Description of the DIP
switch settings" on page 9 for information on these functions.
Figure 4: DIP switch layout (located on rear of camera)
8
Open collector. Compliant with 48 V external power.
Screw terminal
OFF
ON (Default)
UltraView IP Box Day/Night Range Camera User Manual