Extending The Cooling Down Time; Minimum Iron - Miele T 8903 C Operating Instructions Manual

Extending the cooling down
time
The cooling down phase which takes
place before the end of a programme
can be lengthened if required. This
makes the garments easier to handle.
The extension of the cooling down
phase is not a factory standard setting.
It can be extended in two steps.
It can be adjusted for Cottons,
Minimum iron, Delicates.
Follow steps (A,B,C ...) with the
help of the Start button and
programme selector to programme
and store in memory.
Before you begin, first ensure that:
– The dryer is switched off.
– The door is closed.
– The programme selector is turned to
Finish.
A Press the Start/Stop button and keep
it pressed in whilst carrying out steps
B-C.
B Switch the dryer on.
C Wait until Start lights up
constantly. . .
D . . . and then release the Start button.
Programmable functions
E Turn the programme selector to
Smoothing.
The Finish/Anti-crease indicator light
will flash 7 times.
The flashing Drying indicator light
shows which option is selected.
– The Drying indicator light doesn't
flash:
Factory default setting.
– The Drying indicator light flashes
once:
Cooling down phase is 5 minutes
longer.
– The Drying indicator light flashes
twice:
Cooling down phase is 10 minutes
longer.
F You can switch from one option to
the other by pressing the Start button
(Drying indicator light).
G Switch the dryer off.
The setting you have selected is now
stored in memory. You can alter the
settings again at any time.
Control
^ Repeat steps A to E.
^ After checking the indicator lights
(see above), switch the dryer off.
45