Advertisement
Wheelchair Frame
Bracket Clamps
Locknuts
Triangular Assembly
NOTE: Right side Front Anti-Tipper pictured.
ADJUSTING FRONT ANTI-TIPPERS
(FIGURE 2)
NOTE: Refer to the INSTALLATION WARNINGS in
the SAFETY SUMMARY of this instruction sheet.
1. Measure from the floor to the bottom of the wheels of
the triangular assembly.
2. Perform one (1) of the following:
TRIANGULAR ASSEMBLY 3/4-INCH FROM
FLOOR - Repeat STEP 1 for the opposite trian-
gular assembly.
TRIANGULAR ASSEMBLY NOT 3/4-INCH
FROM FLOOR - Proceed to STEP 3.
3. Remove the machine screw, washers and locknut
securing the triangular assembly to the bottom of the
anti-tipper arm.
4. Position the triangular assembly mounting hole to align
with one (1) of the adjustment holes in the anti-tipper
arm.
5. Measure from the floor to the bottom of the wheels of
the triangular assembly.
INVACARE CORPORATION ONE INVACARE WAY
Customer Service 1-800-333-6900
Form No. 81-51
Part No. 1027423
6. Repeat STEPS 4-5 until the bottom of the wheels of
the triangular assembly measure approximately
Lug Bolts
3/4-inch from the floor.
Front Caster
7. Secure the triangular assembly to the bottom of the
Attaches Here
anti-tipper arm with the machine screw, washers and
(not shown for
locknut.
clarity)
DO NOT overtighten the locknut securing the
Anti-Tipper
triangular assembly to the bottom of the anti-
Arm
tipper arm. Otherwise, anti-tipper arm will not
swing freely and the wheelchair may tip over,
resulting in injury or damage.
8. Tighten the locknut until the triangular assembly
does not rattle, but swings freely at the end of the
anti-tipper arm.
9. Repeat STEPS 1-2 for the opposite triangular as-
sembly.
Adjustment
Holes
Locknut
FIGURE 2 - ADJUSTING FRONT ANTI-TIPPERS
Technical Support - 1-800-832-4707
Rev. (1)-3/99
WARNING
Anti-Tipper Arm
Washer
Triangular
Assembly
é
ê
FLOOR
Elyria, OH 44036-2125
Machine
Screw
Mounting
Holes
Wheel
3/4-inch
Printed in U.S.A.
Advertisement
