Wharfedale Pro Titan 8 Passive Operating Manual And User Manual page 19

Titan™ 8/12/15 ACTIVE Rear Panel Features
1. Heat Sink: The heat sink allows for dissipation of heat built up from the amplifier
2. HI and LOW EQ (equalization) controls: These knobs control the equalization of
3. POWER ´ON´ indicator LED and LIMIT indicator LED: The bracketed LED to the left
4. VOLUME controls for INPUT A and INPUT B: These knobs control the volume of
5. POWER ON / OFF switch: This switch: tums the power on and off.
6. RCA L / R (Left and Right) input jacks: These jacks provide for the input of a stereo
7. "BRO™" Bass Response Optimizer circuit switch: The BRO™ circuit, when
8. GAIN selection switch: This switch selects the proper gain structure for INPUT A. If
9. Output source "LOOP / MIX" switch: In the "LOOP" mode, this switch routes the
10. XLR / ¼" COMBO input jacks for INPUT A and INPUT B: These convenient jacks
11. POWER cord jack: This is a jack for a standard IEC, three prong, grounded AC
12. XLR line level OUTPUT jack: This jack provides a balanced line level output of
via air cooling at the rear of the enclosure.
the overall output signal providing +/- 10dB in each frequency range.
of the POWER switch illuminates when the power switch is in the´ON´ position.
The LIMIT LED illuminates when the signal limiter is actively limiting the level of
the signal to prevent distortion and overload.
™
each input channel (Titan 8 VOLUME controls is MAIN) .
signal (left and right). The signal is actively combined or "summed" providing a
mono signal to the amplifier.
engaged, allows for enhanced low frequency response at lower volume levels.
a microphone is connected to INPUT A, use the HIGH selection (up). If the signal
source is anything other than a microphone (playback device, keyboard or mixer
output, for instance) use the LOW selection (down) .
signal of INPUT B to the line level XLR OUTPUT jack, bypassing the EQ section and
volume control. When in the MIX mode, this switch routes the combined (or
"mixed") signals of both INPUT A and INPUT B to the line level XLR OUTPUT jack.
provide for either XLR or ¼" balanced input connections to INPUT A and INPUT B
(Titan™ 8 XLR ¼" COMBO input jacks for INPUT ).
electrical connection cord. Be sure that you are plugging into the correct source
voltage that matches what is indicated just below the power cord jack.
INPUT A and INPUT B signals (in MIX mode) or INPUT B signal only (in LOOP mode)
for connection to additional Titan™ 12 / 15 ACTIVES, powered subwoofers or
amplifiers.
Titan Series
TM
14