Dremel ADVANTAG 9000 Owner's Manual page 6

DM 2610930129 4-05 pt.1
Make certain that the collet
WARNING
!
nut is securely tightened,
auxiliary handle and the depth guide are
installed properly before turning the tool
on.
INSTALLING BITS
The bits are held by a collet system. Use
either a 1/8" or 1/4" collet (not included)
depending on the size of the bit shank.
1/8"
1/4"
(not included)
The bit flutes are sharp and
WARNING
!
should be handled with
caution.
Depress and hold the shaft-lock in and rotate
the collet nut and shaft until the shaft-lock
engages and holds the shaft. Use the
standard equipment wrench to loosen nut
(counter-clockwise). Remove the old bit (if
there is one) insert the new bit as far as
possible, but not so far that the bit flutes
engage the collet (leave approximately 1/8"
of shank exposed). Re-engage the shaft-lock
and tighten the nut (clockwise) by hand and
then with the wrench until bit is held securely.
Removing and installing the handle
Handle slides onto notches
4/4/05 9:29 PM Page 6
Assembly
REMOVING AND INSTALLING DEPTH
The depth guide assembly consists of the
depth guide and depth guide bracket. To
detach, loosen the bracket nut and twist the
whole assembly 1/4 turn and pull straight off
the tool. To reattach the assembly, align the
two pegs inside the bracket with the grooves
on the tool collar and twist 1/4 turn, then
tighten the bracket nut.
REMOVING AND INSTALLING
To remove, first detach the depth guide
assembly. Then release the locking lever and
pull handle off tool. To install the handle, first
detach the depth guide assembly. Align the
two wedges inside the handle with the two
notches on the housing and slide the handle
onto the housing until fully seated. Flip the
lever closed.
LOCKING LEVER
Page 6
GUIDE ASSEMBLY
AUXILIARY HANDLE
Tool with
handle