Table of Contents
Advertisement
Appendix
A. Troubleshooting
Power-On-Self-Test
After the power has been turned on, Video Server will perform a self-diagnostic to detect
any possible hardware defects. If the power indicator is dim at the beginning, the system
fails to proceed further without power. While the POST is proceeding, the status LED
indicators will keep blinking interchanged until finished or any fatal error happens. If
either status LED indicator is dim at the beginning, the LED may be broken.
Any possible fatal error has a special pattern shown in the following table. LED1 is the
one below power indicator and LED2 is the lowest one.
LED pattern after POST Failed function
LED2 and LED3 blink at
same time
LED2 ON and LED3 OFF
LED2 OFF and LED3 ON
LED2 ON and LED3 ON
LED2 blink and LED3 ON
LED2 ON and LED3 blink
To reduce the system failure caused by operation error, always read the related
sections in this user's manual to prevent from unexpected error caused by wild-guess
configuration.
Video input
Ethernet network
Ethernet network
Ethernet interface
System date and time
Camera control via COM or
modem interface
- 60 -
Troubleshooting
The video decoder is broken. Ask
your reseller for technical service.
The PCI interface cannot work. Ask
your reseller for technical service.
The Ethernet controller is broken.
Ask your reseller for technical
service.
Ethernet interface failure includes
not only components on board but
also Ethernet cable and the
devices of the opposite end.
The real-time clock is broken. Ask
your reseller for technical service.
The UART controller is broken. Ask
your reseller for technical service.
Advertisement
Table of Contents
