Table of Contents
Advertisement
rejects upon any failure. Some ISP may reject the mail if the address is invalid.
FTP settings
To send the log files described in the above paragraph via FTP, the SMTP server should be
erased. Administrators must enter correct "Primary FTP Server", "Primary FTP user
name" and "Primary FTP password". "Primary FTP remote folder" is the relative
sub-folder in the remote FTP server. If the port of the remote FTP server is changed other
than 21, set the real port to "Primary FTP server port". If the local network is
protected by a firewall to prevent from initiating FTP connection from the remote FTP
server, you may be able to connect to the FTP server but unable to put any file due to
data channel connection failure. Check "Primary FTP passive mode" for passive
transfer solution. Another set of "Secondary" server settings is also provided for backup
connection.
In either e-mail or FTP, the primary server information should be entered first. If the
primary server is not set, the related FTP or email will be cancelled. Note that it may take
time to connect to the secondary server after the first one fails and it may affect some
applications when conditions happen too often.
After everything is set, click on
. A warning message will pop out for confirmation.
After clicking on
, Video Server will automatically restart. If "Reset network at
next boot" is kept checked, perform software installation again. Otherwise Video Server
will boot up according to the new configuration automatically.
Any change made to this page will make the system restart to validate. Make sure
every field is correctly typed before clicking on
. If Video Server fails to response
due to erratic settings, perform the restore procedures and run software installation.
Administrators should notice that the basic network settings including IP address,
subnet mask, default router and DNS servers will be cleared when the network interface
is switched to the other between Ethernet and modem.
Video and motion detection
Adjust image settings
"Time stamp" and "Text on image" will be enclosed in image for reference. The
timestamp is captured from date and time of Video Server that is maintained by an
on-board real-time clock. "Color" setting is independent of the connected camera and
"B/W" option can speed up the encoder a little. "Default size" option here will be the
- 33 -
Advertisement
Table of Contents
