Plaving And Recording; Playing A Source - Yamaha RX-397 Owner's Manual

PLAYING AND RECORDING
CAUTION
Extreme caution should be exercised when you play back CDs encoded in DTS.
If you play back a CD encoded in DTS on a DTS-incompatible CD player, you will only hear some unwanted noise that may damage
your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output level of your CD player
before you play back a CD encoded in DTS.
2
Press SPEAKERS A and/or SPEAKERS B on
the front panel or on the remote control to
select speakers A and/or speakers B.
Remote control
or
SPEAKERS
A B
Front panel
4
Rotate VOLUME on the front panel (or press
VOLUME
+/-
on the remote control) to adjust
the sound output level.
3
Play the source.
• Both SPEAKERS A and B can be selected.
• Make sure that the IMPEDANCE SELECTOR switch is
correctly set (see page 13).
4
2
4
2
1
5 1
Remote control
or
or
Front panel
5
Press STANDBY/ON on the front panel again
(or press STANDBY on the remote control) to
finish using this unit and set it to the standby
mode.
Remote control
or
Front panel
You cannot select any input source while the TAPE MON
indicator lights up in the front panel display.
1
Rotate the INPUT selector on the front panel
(or press one of the input selector buttons on
the remote control) to select the desired
input source.
Front panel Remote control
15
PLAYING AND RECORDING
CAUTION
Extreme caution should be exercised when you play back CDs encoded in DTS.
If you play back a CD encoded in DTS on a DTS-incompatible CD player, you will only hear some unwanted noise that may damage
your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output level of your CD player
before you play back a CD encoded in DTS.
2
Press SPEAKERS A and/or SPEAKERS B on
the front panel or on the remote control to
select speakers A and/or speakers B.
Remote control
or
SPEAKERS
A B
Front panel
4
Rotate VOLUME on the front panel (or press
VOLUME
+/-
on the remote control) to adjust
the sound output level.
3
Play the source.
• Both SPEAKERS A and B can be selected.
• Make sure that the IMPEDANCE SELECTOR switch is
correctly set (see page 13).
4
2
4
2
1
5 1
Remote control
or
or
Front panel
5
Press STANDBY/ON on the front panel again
(or press STANDBY on the remote control) to
finish using this unit and set it to the standby
mode.
Remote control
or
Front panel
You cannot select any input source while the TAPE MON
indicator lights up in the front panel display.
1
Rotate the INPUT selector on the front panel
(or press one of the input selector buttons on
the remote control) to select the desired
input source.
Front panel Remote control
15