Gear Case Oil
1.
Park the ATV on level ground.
2.
Place an oil drain pan under the oil drain plug ( ).
3.
Remove the oil filler cap ( ), drain plug and sealing washer ( ).
4.
After the oil has completely drained, reinstall the drain plug with a
new sealing washer and tighten it to the specified torque:
9 lbf·ft (12 N·m , 1.2 kgf·m)
5.
Pour the drained oil into a suitable container and dispose of it in an
approved manner (page
Improper disposal of drained f luids is harmf ul to the environment.
6.
Fill the gear case with the recommended oil.
2.5 US oz (75 cm )
7.
Remove the oil level check bolt ( ) and sealing washer. Make sure
the oil level reaches the oil level check hole ( ).
8.
Install the oil filler cap and oil level check bolt with a new sealing
washer.
REAR
(5)
(4)
(3)
(1) oil drain plug
(2) oil filler cap
(3) sealing washers
164
Servicing Your Honda
1
2
230
).
4
5
(3)
(4) oil level check bolt
(5) oil level check hole
3
(2)
(1)