Water-Stop Device - AEG Electrolux Lavamat64840L User Manual

3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4"
thread. Always use the hose supplied with
the appliance.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
Installation should comply with local water
authority and building regulations require-
ments. Check the minimum water pressure
required for safe operation of the appliance in
the chapter "Technical Data".

Water-stop device

The inlet hose is provided with a water stop device,
which protects against damage caused by water
leaks in the hose which could develop due to nat-
ural ageing of the hose. This fault is shown by a
red sector in the window «A» . Should this occur,
turn the water tap off and refer to your Service
Centre to replace the hose.
WARNING!
Installation should comply with local water authority and building regulations' re-
quirements.
The appliance must be connected to a cold water supply.
A minimum water pressure of 0.05 MPa (0.5 bar) is required for safe operation of the
appliance.
If you cannot make the cold water connection direct from the rising mains, you may be
able to operate the appliance from your cold water storage system.
There should be a minimum vertical distance of 5.02 m (16.5 ft) between the appliance's
inlet and the bottom of the water storage tank.
31
Installation