Water-Stop Device; Water Drainage - AEG Electrolux LAVAMAT 74650 User Manual

40 Installation
3. Set the hose correctly by loosening the ring nut. After positioning the inlet
hose, be sure to tighten the ring nut again to prevent leaks.
4. Connect the hose to a tap with a 3/4" thread.
Always use the hose supplied with the appliance.
Installation should comply with local water authority
and building regulations requirements. Check the
minimum water pressure required for safe operation of
the appliance in the chapter "Technical Data".
If you cannot make the cold water connection direct
from the rising mains, you may be able to operate the
appliance from your cold water storage system. There should be a minimum verti-
cal distance of 16.5 feet between the appliance's inlet and the bottom of the water
storage tank.

Water-stop device

The inlet hose is provided with a water stop device,
which protects against damage caused by water leaks
in the hose which could develop due to natural ageing
of the hose. This fault is shown by a red sector in the
window "A". Should this occur, turn the water tap off
and refer to your Service Centre to replace the hose.

Water drainage

This appliance is designed to be permanently plumbed
into your home's drainage system using one of the fol-
lowing methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose using the
"U" piece" supplied.
Place the drain hose into your stand-
pipe, which should have an internal
diameter of approximately 38mm thus
ensuring there is an air break between
the drain hose and standpipe.
U